Detailed technical parameters of sanitary centrifugal pump

Generally, the installation foundation of sanitary centrifugal pump shall be flat and well grounded. As far as possible, install it at the lowest point of the equipment, i.e. the maximum lifting height.
The pipe diameter of the sanitary centrifugal pump must be the same as that of the pump inlet and outlet, and the diameter of the inlet pipe cannot be too small. (if the diameter of the pipe is smaller than the diameter of the pump, use an eccentric reducer to adjust to minimize the diameter of the pipe to avoid dents.) If the outlet diameter is too large, try not to. If the outlet diameter is larger than the pump outlet, try to extend the distance from the pump outlet to avoid overloading the pump motor.

Technical parameters of sanitary centrifugal pump
1. Working voltage:
≤3Kw，220-240V/380-420V，△/Y
＞3Kw，380-420V/660-690V, △/Y
2. Frequency: 50Hz / 60Hz
3. The three-phase AC motor is mainly used according to the configuration. It is designed and manufactured according to iec60034.iec60072 standard of International Electrotechnical Commission and meets the requirements of "CE" mark of European Union.
4. Excellent electrical performance, low noise and vibration. The standard design protection level of the motor is IP55 and the insulation level is f.
5. Working mode: continuous (SI)
6. Speed: standard pump speed is 2900r / min technical parameters
7. Specification: 3t-180t, 0.55kw-75kw
8. Material: SUS304 SUS316L (when selecting materials) upper pump body, pump cover, impeller and other parts in contact with materials are made of SUS316L or susi304 stainless steel)
9. The explosion-proof motor can meet the needs of different situations.
10. Service conditions: high and low liquid level horizontal transportation of sanitary centrifugal pump, not self-priming. (select self-priming pump for self-priming)
11. Surface treatment: polishing of wet parts, other matte or sandblasting.